#HEATED SCARF SKIN#

A person who is paralyzed or has skin that is sensitive to temperature changes.

If it is unreadable or missing, email ORORO customer service at.

Maintain labels that carry important information.

Follow instructions given on the washing label or in the CLEANING INSTRUCTIONS section of this manual.

Discontinue use immediately If the product does not operate properly.

Shut off the power immediately if any discomfort occurs.

Some medical conditions, medical devices, or medications can cause sensitivity to heat.

Consult your physician to determine if using this product is appropriate.

Use of the product for operations different from those intended could result in a hazardous situation.

Use the product in accordance with these instructions, taking into account the environment in which the product is to be worn.

Such preventive safety measures reduce the risk of the product starting accidentally.

Disconnect the battery from the power cable and remove the battery pack before storing or hand washing the product.

Water entering the scarf will increase the risk of electric shock.

Allow the product to dry completely before wearing if the inner lining becomes wet.

Failure to follow the warnings and instructions may result in electric shock, fire, and/or serious injury.

Read all safety warnings and instructions below. HEATED SCARF SAFETY INFORMATION & WARNINGS To avoid burns, never use the product when sleeping. (The temperature data is obtained by measuring the heating elements.) At a room temperature of 77вЏ/25вЊ, the scarf can heat up to 127вЏ/53вЊ on high, 113вЏ/45вЊ on medium, and 100вЏ/38вЊ on low.

The heating level can be adjusted by pressing the power button. To turn off, press and hold the power button for 3 seconds until LEDs turn off.Then it will automatically adjust to medium heat (white LED light). The scarf will start pre-heating with red LED light blinking (for 5 minutes). To activate, press and hold the power button for 3 seconds.Pull out the power connector and insert it into the port on the battery.The LED light on the charger should turn green from red when the battery fully charged

Charge the battery fully before first use.